PHOTO ANGLE: Rear of car looking directly forward into engine compartment
The rear shock tower and fire wall as well as motor mount bars can be seen here
SPECIAL INTEREST: Note the piece of square tubing on the floor of the front tunnel. This is a stand of for the center hiem Guide for the shifter
PHOTO ANGLE: Passenger side rear quarter looking into engine compartment
Here can be seen the radiator support frame and left polished fuel tank
SPECIAL INTEREST: Note the polished sheet of 6160 aluminum on the front fire wall
PHOTO ANGLE: Driver side rear quarter panel looking into engine compartment
This view shows the molded tunnel enclosure for the nose of the motor as well as the frame and the inside of the NACA duct opening on the right
SPECIAL INTEREST: Note the "Cobra" trunk hinges used for the engine lid at the top of the engine compartment opening
PHOTO ANGLE: Drivers side through door opening ,into passenger compartment
Clutch and brake pedals installed. Tube tunnel for shifter and hose and wiring from engine.
SPECIAL INTEREST: Note the bracket and handle location for the Lokar emergency brake on the side of the tunnel. Also, you can observe the floor pan of the engine compartment which is 3/8 inch thick sheet steel.
PHOTO ANGLE: Rear of car looking directly forward
This is a photo of the car after painting outside curing
SPECIAL INTEREST: Note the custom roll around cart made just for the car
PHOTO ANGLE: Passenger side rear
Good view if the car from the left rear quarter
SPECIAL INTEREST: Note the finish of the left inner rear fender well
PHOTO ANGLE: Driver side rear
Another view of the rear valance and chassis
SPECIAL INTEREST: Note the NACA duct area has been painted black