PHOTO ANGLE: Driver side engine compartment looking forward and down into intake air duct area.
This photo shows the back side of the passenger fire wall. Also the curved Chassis tubing area is the location of one of the two 10 gallon fuel tanks.
SPECIAL INTEREST: Note the NACA air duct opening from the back side. Also, note the extensive body work on the fire wall as well as the inside curve of the body.
PHOTO ANGLE: Passenger side front wheel well looking forward
Here the custom frame for the front heat light pod can be seen
SPECIAL INTEREST: Note the 1995 Firebird headlight motor installed in the frame work
PHOTO ANGLE: Driver side engine compartment looking down and forward
The initial test fit of a mockup engine block and transaxle is shown
SPECIAL INTEREST: Note the coil over spread bar over the bell housing as well as the removable chassis suspension link attachment directly behind the spread bar. Also the front firewall tunnel for the nose of the motor has also been molded in.
PHOTO ANGLE: Passenger side straight on
The final attachment of the body to the chassis has been completed in this photo. The doors have yet to be rebuilt and fit into place
SPECIAL INTEREST: Note the 1987 Fiero tilt steering column.
PHOTO ANGLE: Driver side Front Quarter
Another view of the "rake" of the body on the frame
SPECIAL INTEREST: Note the NACA duct opening has been cut out
PHOTO ANGLE: Passenger side front quarter
The headlight pods and parking/turn buckets can be seen
SPECIAL INTEREST: Note that the Roll Bar Cage and body integration has been started and the first layer of fiberglass paste has been worked into the space between the bar and the windshield pillar
PHOTO ANGLE: Passenger side Rear Quarter looking forward
The doors have been rebuilt and fit in this photo
SPECIAL INTEREST: Note the extensive body work on the NACA duct area for proper alignment