Parking light pods, and cut out access in front storage area for brake and clutch Hydraulics and Heater core.
SPECIAL INTEREST: Note the ROLL BAR CAGE that will be integrated into the body.
PHOTO ANGLE: Passenger side
Initial fitting of body to frame
SPECIAL INTEREST: Note inner front fender well. Custom curved to allow for tire clearance and to seal off passenger compartment from elements
PHOTO ANGLE: Passenger side.
Initial completion of rear fire wall and rough fit Of door sills.
SPECIAL INTEREST: Note the roll cage that will be integrated to the body. Also note the rear fire wall is flat. Will need to re cut and create a recess into the passenger compartment for clearance for the front of the engine.
PHOTO ANGLE: Passenger side through the door opening into the passenger compartment,
Inner door sills installed, Heater core and A/C evaporator tubing coming out of the firewall
SPECIAL INTEREST: Note the oval recess on drivers lower door sill for the electrically remote actuated trunk and engine lid releases. Also the tunnel protrusion of the fire wall into the passenger compartment has been completed. The tunnel is a reduced copy of the center console so the console will fit snuggly over it.
PHOTO ANGLE: Passenger Side Rear Wheel well looking back.
This photo shows the left rear main body and chassis attachment point.
SPECIAL INTEREST: Note the attachment plates have slotted holes to allow for vertical height adjustment and proper wheel well clearance.
PHOTO ANGLE: Left side through the engine compartment
Tube frame and inner right fender well
SPECIAL INTEREST: Note the Corvette C-4 Upright rear suspension.
PHOTO ANGLE: Drivers side through wind screen opening
Top of front suspension. Coil over brackets.
SPECIAL INTEREST: Note the support tab for center of front cowling located on the top of the spread bar. It is adjustable to obtain the correct curvature.